Relative growth rate

From testwiki
Jump to navigation Jump to search

Template:Short description Relative growth rate (RGR) is growth rate relative to size - that is, a rate of growth per unit time, as a proportion of its size at that moment in time. It is also called the exponential growth rate, or the continuous growth rate.

Rationale

RGR is a concept relevant in cases where the increase in a state variable over time is proportional to the value of that state variable at the beginning of a time period. In terms of differential equations, if S is the current size, and dSdt its growth rate, then relative growth rate is

RGR=1SdSdt.

If the RGR is constant, i.e.,

1SdSdt=k,

a solution to this equation is

S(t)=S0exp(kt)

Where:

  • S(t) is the final size at time (t).
  • S0 is the initial size.
  • k is the relative growth rate.

A closely related concept is doubling time.

Calculations

In the simplest case of observations at two time points, RGR is calculated using the following equation:[1]

RGR = ln(S2)  ln(S1)t2  t1,

where:

ln = natural logarithm

t1 = time one (e.g. in days)

t2 = time two (e.g. in days)

S1 = size at time one

S2 = size at time two

When calculating or discussing relative growth rate, it is important to pay attention to the units of time being considered.[2]

For example, if an initial population of S0 bacteria doubles every twenty minutes, then at time interval t it is given by solving the equation:

S(t) = S0exp(ln(2)t)=S02t

where t is the number of twenty-minute intervals that have passed. However, we usually prefer to measure time in hours or minutes, and it is not difficult to change the units of time. For example, since 1 hour is 3 twenty-minute intervals, the population in one hour is S(3)=S023. The hourly growth factor is 8, which means that for every 1 at the beginning of the hour, there are 8 by the end. Indeed,

S(t) = S0exp(ln(8)t)=S08t

where t is measured in hours, and the relative growth rate may be expressed as ln(2) or approximately 69% per twenty minutes, and as ln(8) or approximately 208% per hour.[2]

RGR of plants

In plant physiology, RGR is widely used to quantify the speed of plant growth. It is part of a set of equations and conceptual models that are commonly referred to as Plant growth analysis, and is further discussed in that section.

See also

References

Template:Reflist