Mason–Weaver equation

From testwiki
Jump to navigation Jump to search

The Mason–Weaver equation (named after Max Mason and Warren Weaver) describes the sedimentation and diffusion of solutes under a uniform force, usually a gravitational field.[1] Assuming that the gravitational field is aligned in the z direction (Fig. 1), the Mason–Weaver equation may be written

∂c∂t=D∂2c∂z2+sg∂c∂z

where t is the time, c is the solute concentration (moles per unit length in the z-direction), and the parameters D, s, and g represent the solute diffusion constant, sedimentation coefficient and the (presumed constant) acceleration of gravity, respectively.

The Mason–Weaver equation is complemented by the boundary conditions D∂c∂z+sgc=0 at the top and bottom of the cell, denoted as za and zb, respectively (Fig. 1). These boundary conditions correspond to the physical requirement that no solute pass through the top and bottom of the cell, i.e., that the flux there be zero. The cell is assumed to be rectangular and aligned with the Cartesian axes (Fig. 1), so that the net flux through the side walls is likewise zero. Hence, the total amount of solute in the cell Ntot=∫zbzadz c(z,t) is conserved, i.e., dNtot/dt=0.

Derivation of the Mason–Weaver equation

Figure 1: Diagram of Mason–Weaver cell and Forces on Solute

A typical particle of mass m moving with vertical velocity v is acted upon by three forces (Fig. 1): the drag force fv, the force of gravity mg and the buoyant force ρVg, where g is the acceleration of gravity, V is the solute particle volume and ρ is the solvent density. At equilibrium (typically reached in roughly 10 ns for molecular solutes), the particle attains a terminal velocity vterm where the three forces are balanced. Since V equals the particle mass m times its partial specific volume ν¯, the equilibrium condition may be written as

fvterm=m(1−ν¯ρ)g =def mbg

where mb is the buoyant mass.

We define the Mason–Weaver sedimentation coefficient s =def mb/f=vterm/g. Since the drag coefficient f is related to the diffusion constant D by the Einstein relation

D=kBTf,

the ratio of s and D equals

sD=mbkBT

where kB is the Boltzmann constant and T is the temperature in kelvins.

The flux J at any point is given by

J=−D∂c∂z−vtermc=−D∂c∂z−sgc.

The first term describes the flux due to diffusion down a concentration gradient, whereas the second term describes the convective flux due to the average velocity vterm of the particles. A positive net flux out of a small volume produces a negative change in the local concentration within that volume

∂c∂t=−∂J∂z.

Substituting the equation for the flux J produces the Mason–Weaver equation

∂c∂t=D∂2c∂z2+sg∂c∂z.

The dimensionless Mason–Weaver equation

The parameters D, s and g determine a length scale z0

z0 =def Dsg

and a time scale t0

t0 =def Ds2g2

Defining the dimensionless variables ζ =def z/z0 and τ =def t/t0, the Mason–Weaver equation becomes

∂c∂τ=∂2c∂ζ2+∂c∂ζ

subject to the boundary conditions

∂c∂ζ+c=0 at the top and bottom of the cell, ζa and ζb, respectively.

Solution of the Mason–Weaver equation

This partial differential equation may be solved by separation of variables. Defining c(ζ,τ) =def e−ζ/2T(τ)P(ζ), we obtain two ordinary differential equations coupled by a constant β

dTdτ+βT=0

d2Pdζ2+[β−14]P=0

where acceptable values of β are defined by the boundary conditions

dPdζ+12P=0

at the upper and lower boundaries, ζa and ζb, respectively. Since the T equation has the solution T(τ)=T0e−βτ, where T0 is a constant, the Mason–Weaver equation is reduced to solving for the function P(ζ).

The ordinary differential equation for P and its boundary conditions satisfy the criteria for a Sturm–Liouville problem, from which several conclusions follow. First, there is a discrete set of orthonormal eigenfunctions Pk(ζ) that satisfy the ordinary differential equation and boundary conditions. Second, the corresponding eigenvalues βk are real, bounded below by a lowest eigenvalue β0 and grow asymptotically like k2 where the nonnegative integer k is the rank of the eigenvalue. (In our case, the lowest eigenvalue is zero, corresponding to the equilibrium solution.) Third, the eigenfunctions form a complete set; any solution for c(ζ,τ) can be expressed as a weighted sum of the eigenfunctions

c(ζ,τ)=∑k=0∞ckPk(ζ)e−βkτ

where ck are constant coefficients determined from the initial distribution c(ζ,τ=0)

ck=∫ζaζbdζ c(ζ,τ=0)eζ/2Pk(ζ)

At equilibrium, β=0 (by definition) and the equilibrium concentration distribution is

e−ζ/2P0(ζ)=Be−ζ=Be−mbgz/kBT

which agrees with the Boltzmann distribution. The P0(ζ) function satisfies the ordinary differential equation and boundary conditions at all values of ζ (as may be verified by substitution), and the constant B may be determined from the total amount of solute

B=NtotsgD1e−ζb−e−ζa

To find the non-equilibrium values of the eigenvalues βk, we proceed as follows. The P equation has the form of a simple harmonic oscillator with solutions P(ζ)=eiωkζ where

ωk=±βk−14

Depending on the value of βk, ωk is either purely real (βk≥14) or purely imaginary (βk<14). Only one purely imaginary solution can satisfy the boundary conditions, namely, the equilibrium solution. Hence, the non-equilibrium eigenfunctions can be written as

P(ζ)=Acos⁡ωkζ+Bsin⁡ωkζ

where A and B are constants and ω is real and strictly positive.

By introducing the oscillator amplitude ρ and phase φ as new variables,

u =def ρsin⁡(φ) =def P

v =def ρcos⁡(φ) =def −1ω(dPdζ)

ρ =def u2+v2

tan⁡(φ) =def vu

the second-order equation for P is factored into two simple first-order equations

dρdζ=0

dφdζ=ω

Remarkably, the transformed boundary conditions are independent of ρ and the endpoints ζa and ζb

tan⁡(φa)=tan⁡(φb)=12ωk

Therefore, we obtain an equation

φa−φb+kπ=kπ=∫ζbζadζ dφdζ=ωk(ζa−ζb)

giving an exact solution for the frequencies ωk

ωk=kπζa−ζb

The eigenfrequencies ωk are positive as required, since ζa>ζb, and comprise the set of harmonics of the fundamental frequency ω1 =def π/(ζa−ζb). Finally, the eigenvalues βk can be derived from ωk

βk=ωk2+14

Taken together, the non-equilibrium components of the solution correspond to a Fourier series decomposition of the initial concentration distribution c(ζ,τ=0) multiplied by the weighting function eζ/2. Each Fourier component decays independently as e−βkτ, where βk is given above in terms of the Fourier series frequencies ωk.

See also

  • Lamm equation
  • The Archibald approach, and a simpler presentation of the basic physics of the Mason–Weaver equation than the original.[2]

References

Template:Reflist