Search results

...tted throughout the liquid and against the bottom of the right piston (The pistons are simply "plugs" that can slide freely but snugly inside the tube.). The ...ices ranging from very small to enormous. For example, there are hydraulic pistons in almost all construction machines where heavy loads are involved. ...

...Lakers]], and twice each to players on the [[Chicago Bulls]] and [[Detroit Pistons]].<ref name=NBAGuide /> [[David Robinson (basketball)|David Robinson]] won | [[Detroit Pistons]] ...

...ed system|closed thermodynamic system]]. In addition, the cylinder and the pistons are assumed to be rigid, massless, and [[Adiabatic process|adiabatic]].<ref ...

...s only useful for a few runs, as is also the case for the tungsten carbide pistons. The expense of using such a device is great. ...

...778–87 | pmid = 19378977 }}</ref> (good for large changes in pressure) or pistons operated by [[piezoelectricity#Actuators|piezoelectric actuators]]<ref name ...

...ensional paper is not usually a serious limitation. In some cases, such as pistons for internal combustion engines, three-dimensional modelling may be require ...

...Won''' [[1975 NBA playoffs|First round]] ([[1974–75 Detroit Pistons season|Pistons]]) 2–1<br>Lost Conference semifinals ([[1974–75 Golden State Warriors seaso ...

...al overlap and 7&nbsp;mm negative external overlap, while the low-pressure pistons had a 430&nbsp;mm diameter, 39&nbsp;mm internal overlap and 4&nbsp;mm negat ...

Journal bearings on the crankshaft and connecting rods and the pistons sliding in their cylinders operate in the [[Fluid bearing#Hydrodynamic lubr ...

...|ventilation system]] drives the small amount of gas that escapes past the pistons during normal operation (the blow-by gases) out of the crankcase so that it ...nctions. The cylinder head seals the cylinders on the side opposite to the pistons; it contains short ducts (the ''ports'') for intake and exhaust and the ass ...

...t, and while the "standard" turbo compression ratio was still 8:1, special pistons sourced from [[Cosworth]] would lower it even further to 7.2:1 to permit th ...-turbo conversion.<ref name="race-cars-ad"/> This engine used the Cosworth pistons, Weber carburretion and water injection to cool the intake charge. Output w ...

...onadiabatic, open systems), and the boundaries are moving (usually through pistons). In our formulation we assume that heat and mass transfer and volume chang ...

If a mill stand is fitted with hydraulic pistons in series with, or instead of the electrically driven mechanical screws, th ...

...uels. Carbon is routinely left as a black deposit on engine parts, such as pistons, rings, and valves, by the [[combustion]] of fuel. ...

...ch?v=sdPR_U6IvNA |access-date=2023-12-10 |language=en}}</ref> motor hollow pistons, passenger car wheel rims, converter for passenger car automatic gears, [[D ...

...past, elevator drive mechanisms were powered by steam and water hydraulic pistons or by hand. In a "traction" elevator, cars are pulled up by means of rollin ...